Texas Instruments TSC2007EVM-PDK Manuel d'utilisateur télécharger pdf (Page 5)

www.ti.com

6 Kit Operation

6.1 TSC2007EVM-PDK Block Diagram

Kit Operation

Table 6. List of Jumpers

JUMPER SHUNT POSITION JUMPER DESCRIPTION

JMP1 2-3 Analog power select (default is +3.3VD)

JMP2 Closed EEPROM address select. When installed and used with the USB-MODEVM, firmware for the

motherboard is executed from the EEPROM on the TSC2007EVM. This is the default mode.

The following section provides information on using the TSC2007EVM-PDK, including setup, program

installation, and program usage.

A block diagram of the TSC2007EVM-PDK is shown in Figure 1 . The evaluation kit consists of two circuit

boards connected together. The motherboard is designated as the USB-MODEVM interface board; the

daughtercard is the TSC2007EVM described previously in this manual.

SLAU199 – March 2007 TSC2007EVM and TSC2007EVM-PDK User's Guide 5

Submit Documentation Feedback

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Texas Instruments TSC2007EVM-PDK Manuel d'utilisateur Page 5