Texas Instruments TI-34 MultiView Manuel télécharger pdf (Page 44)

How to remove or replace the battery

The TI-34 MultiView™ calculator uses one 3 volt CR2032

lithium battery.

Remove the protective cover and turn the TI-34 MultiView

calculator face downwards.

• With a small screwdriver, remove the screws from the back

of the case.

• From the bottom, carefully separate the front from the

back. Be careful not to damage any of the internal parts.

• With a small screwdriver (if required), remove the battery.

• To replace the battery, check the polarity (+ and -) and

slide in a new battery. Press firmly to snap the new battery

into place.

Important: When replacing the battery, avoid any contact

with the other components of the TI-34 MultiView

calculator.

Dispose of the dead battery immediately and in accordance

with local regulations.

case

difficulty

Review instructions to be certain calculations were performed

properly.

Check the battery to ensure that it is fresh and properly

installed.

Change the battery when:

• & does not turn the unit on, or

• The screen goes blank, or

• You get unexpected results.

1 2 ... 39 40 41 42 43 44 45

Pas de commentaire

Texas Instruments TI-34 MultiView Manuel Page 44